Nothing is displayed by pressing the button. Replace with new batteries according to the procedure speci- fied in the section “Replacing the battery”. Is the computer or sensor battery weak ? In winter, battery performance diminishes. Install the sensor within the specified range. Is the computer installed at the correct angle?īack of computer must face toward the sensor.Ĭheck that the distance between the computer and sensor is correct. (Clearance: withinĕ mm) Check that the magnet passes through the sensor zone correctly.Īdjust the positions of the magnet and sensor. If the sensor signal icon flashes, this trouble may be a matter of transmission distance due to battery drain, but not any malfunction.)Ĭheck that the clearance between the sensor and magnet is not too large. (Move the computer near the sensor, and turn the front wheel. The sensor signal icon does not flash (the speed is not displayed). Insert new lithium batteries (CR2032) with the (+) sign upward, and close the battery cover firmly. When the speed is not displayed even af- ter adjusting correctly, replace the battery. The procedure described in “Preparing the computer” (Pageē). *Ěfter replacing the computer battery, follow Install a new lithium battery(CR2032) with the (+) side facing upward. When (battery icon) is turned on, replace theīattery. To clean the computer or accessories, use diluted neutral detergent on a soft cloth, and wipe it off with a dry cloth.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |